Farmall & IHC Tractors Discussion Board |
F-12 Problems
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RB on May 29, 2000 at 15:31:20 from (12.77.31.146):
FInally a problem with something other than my F-14!Budy of mine bought a F-12.No serial no. plate but by the casting codes its a 36.WHen he got it it had a hole in the block,so he bought a block that is a 35.We rebuilt it and this morning was the first time we fired it off.We wore our arms out turning the crank so we tried pulling it.It hits and misses alot but will not start.It occasionally backfires and when it does it sounds like its doing it on the intake stroke like its sucking in the backfire.Checked engine timing and mag timing and all is right on.No sticking valves and its getting gas to the plugs.All of the usual has been done so I can rule out plugs,wires.points,etc. Any clues?
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|