Posted by D Slater on April 26, 2010 at 17:23:04 from (71.164.38.78):
In Reply to: 350D Injecter Pump posted by Bill46 on April 26, 2010 at 10:25:17:
Bill its over 10 years since I had one. Will put what i think I remember, maybe someone with a fresher memory will post. After the pump is removed the drive shaft will pull out or may come out when pump is removed. Seals can be replaced on the shaft. Shaft has a place on it to match the inside when putting it back, make sure they line up. Under the pump theres a adapter that is turned to adjust the drive gear play, O ring under it and another on top. If no engine oil is leaking out and gear play is okay don't remove the adapter. If drive shaft under pump is left in place the pump shaft will only go back in the same gear time. If pump drive is removed put the slots back in the same direction. Best to remove the timing window on pump first and turn engine until marks are lined up, then do not move engine anymore and line marks back up when installing.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.