|
Farmall & IHC Tractors Discussion Board |
Re: Re: Best finish mower setup- 3 hilly acres?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Paul Shuler on May 26, 2000 at 18:12:29 from (152.163.197.53):
In Reply to: Re: Best finish mower setup- 3 hilly acres? posted by Jim on May 25, 2000 at 10:50:35:
I have a Super C with a NF end but no mower yet.Jerry it's a little smaller than an H and a little bigger than an A,B or cub. It seems to have plenty of power for a belly mower and if you don't live on a place with to steep of hills with that narrow front end you can turn it around on a dime.You might have to trim up your trees a little to keep from getting scuffed up by limbs,it sits a little higher than the smaller tractors.The best part is you can pick up a good one in the $1,200 to $3,000 range depending on how pretty you want it.
Paul
Paul
Follow Ups:
Home
| Forums
Today's Featured Article -
Fasteners: The Nuts and Bolts of Nuts and Bolts - by Curtis Von Fange. The nuts and bolts of nuts and bolts is an interesting and essential piece of knowledge that applies to our older tractors. An improperly torqued capscrew on an engine head or a shear bolt that is too hard on the driving shaft of a bushog can create havoc and make an expensive and uncalled for repair. Let’s examine the purpose and design of these fasteners in order to ensure their proper use. Fasteners are probably one of the aspects of mechanics that is given the least amount of thought.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
