Farmall & IHC Tractors Discussion Board |
Re: Re: Re: truckload picture
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Wardner on May 25, 2000 at 11:42:07 from (63.23.216.66):
In Reply to: Re: Re: truckload picture posted by BobinIL on May 25, 2000 at 06:38:17:
All the sheet metal is the same between the IH and Farmall 560 and 660 with the exception of the verticle panels that cover the sides of the radiator. The 660 has a spliced on piece at the bottom that is about 3 inches high. The grills are the same as well. A cast iron spacer fills the 3 inch space. The radiator is taller to accomodate the higher output engine. The increased output comes from the injector pump that is governed to 2400 rpm. The only other difference between these tractors is the planetary wheel hubs and axel housings. All the rear sheet metal on the standard tread 560 and 660 is the same.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|