Ron, here's a repost of a post I made farther down the page.
If you can measure the primary current as explained below it will show if you have the correct resistor.
"Here's the straight FACTS.
Coils vary in primary resistance depending upon part number, manufacturer and application. Some are as low as 0.5 Ohms, some close to 5 Ohms.
For acceptable breaker point life at a specific system voltage the combination of coil primary resistance and any added external resistance must be such that primary current (ignition "on", points CLOSED, engine stopped) is in the 3 Amp to a maximum of 4 Amps (give or take a little) range.
Less than 3 Amps will PROBABLY give a weak spark, much over 4 Amps will be tough on breaker points.
If you can, when you get your new resistor installed, MEASURE the actual primary current and see where you're at compared to that range.
NOTE... besides different resistance VALUES, ignition resistors may be either fixed resistance or "PTC" (positive temperature coefficient).
With FACTORY systems, generally a FIXED resistance is used with systems that have a "starting bypass" (a separate terminal on the starter switch or solenoid that provides full battery voltage to the coil during cranking).
For FACTORY systems NOT using a "starting bypass", a PTC "ballast resistor" is used. When the ignition is switched "on" the resistor has a relatively low resistance to aid in starting, then it's resistance quickly drops to a higher value as it heats up to prolong point life and cause less heating of the coil.
NAPA, Standard Ignition, BW, etc., have parts guides that will show the resistance for a given part number and whether it's fixed or PTC.
Finding a counterman who is willing to grab that guide and have a look is another matter.
Also, there's "true" 12 Volt coils on the market that have enough primary windings so that no external resistor is needed. NAPA IC-14SB is ONE example of such a coil."
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
