To get started in hard ground the the drawbar needs to be low to the ground to make the point dig in. The plow share or point must be in good condition. If the ground is hard, it will take 3 or more passes to get going. The first pass may only make a slight furrow. As the furrow wheel rides deeper in the furrow with each pass, the plow will go deeper. Also, the hitch has eccentric bolts where the hitch plate with the springs is bolted to the plow beam. You can adjust those bolts to tilt the plow side to side and make the point dig in better. If you jack the tractor up on the land wheel side (on a level surface) to the depth you want to plow and then let the plow down, the plow bottom should be level side to side and the landslide should also be pretty near level front to rear. The plow will also tend to push to the left some. This is normal, so when the plow is out of the ground, it will appear that it can't take a full cut because part of the share is behind the wheel.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.