Posted by ScottyHOMEy on March 12, 2009 at 06:55:57 from (64.222.222.178):
In Reply to: super a clutch posted by Mark W. on March 12, 2009 at 06:28:59:
Yout tractor is right in that era where it could have had one of two types of bearings.
One was the conventional flat faced roller bearing that is pressed into a separate carrier. On that one, you could drive out the bearing and replace it with a new one, using teh same carrier.
The other used a block of a graphite compound as a bearing surface, and the block was part and parcel with the carrier. Pretty easily identified by a slight dish running around its face where the fingers spin around it, as if somebody bad pressed a donut into the surface -- usuall very shiny on the face, looks almost like metal. Replacement in that case meant replacing the carrier with a new one that had a new block of bearing material.
So . . . if your old one was the graphite type, and your kit has the roller bearing, you'll need to get a new carrier for the new bearing. They can be had, but they're a dealer part, so you'll have to limber up the wallet.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.