Posted by farmallhal on March 21, 2010 at 08:05:50 from (71.1.111.67):
In Reply to: 200 2pt to 3pt posted by clint s on March 21, 2010 at 07:41:52:
Clint, I've never used one and in fact never have seen one up close except in pictures. The way they would work is you would install the 3 point portion to the 3 point implement, install the top link bracket to the back of the tractor and then back up with the 2 point fast hitch to insert the prongs into the hitch receivers and attach the top link. Probably will need an additional person to assist getting it hooked up. I note you are asking about a Farmall 200 and guess you know those prongs come in two different sizes. The 200 takes the smaller of them as the receivers are sized to accept only the 2 1/2" smaller prongs. I am a real fan of the two point original equipment so everything I use with my Super C are fast hitch original implements. I do have an IHC 2 point fast hitch to 3 point adapter (never used it though) which is quite a bit different then the aftermarket approach you are looking at. It accomplishs the same task. They show up in the photo adds quite often but only look at the small point models for the 200. Hope this helps, Hal.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
