Posted by Spotted Horse on March 19, 2010 at 21:22:29 from (24.225.2.81):
In Reply to: Hydraulic question posted by Wardner on March 18, 2010 at 20:00:20:
Wardner said: (quoted from post at 20:00:20 03/18/10) I would consider converting the transaxle into a reservoir. Replace the gear oil with Hy-Tran or equivalent. Place a strainer, check valve, and tee at the rear drain plug or a safer remote location with a suction hose. The check valve might not be necessary. It depends how good your pumps are at holding a prime.
Despite what Jim says about the PTO pump, the Prince pump will easily handle 1200 RPM. The same pump is used with 1000 RPM PTO. The mfg changes out the internal splines to suit 540 or 1000 PTO shafts. I can't think of any small hydraulic gear pump that can't run at 2000-2500.
I think I lucked out today, I bought a tank off an old "farmhand" (the kind that has a frame around the tractor and a big hay basket). I'm not sure how much fluid the tank holds but probably at least 10 gallons. :)
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
