Moondoggie said: (quoted from post at 18:16:15 03/07/10) I split the 340U over the last 2 weekends to repair the TA clutch which was non functional. The TA assembly looks good. The pressure plate looks good as well as the back plate and the disk. But I can't get the 19/32" dimension between the the back of the back plate and the bottom of the pressure plate suggested in the IT manual. Seems either the fingers are worn or the surface of the back plate is worn by at least 3/16". At that dimension, the plate would be worn through. Should I just replace the plates and the disc and be done with it? Or am I missing something?
The specification is given for overhauling the pressure plate assembly. That is the dimension used to set the lever height. There should be another spec given for lever height.
When using a clutch stand, the levers are pushed down to the specification given and then they are adjusted until you have 19/32" between the backing plate and the test stand.
When assembling the TA clutch in the tractor you do not need to worry about that spec. As long as there is not excessive wear in any of the parts and when assembled the levers are about parallel with the flywheel you should be good to go.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
