Posted by CNKS on March 06, 2010 at 18:54:43 from (216.144.104.128):
In Reply to: Tool advice posted by MNC on March 06, 2010 at 17:56:43:
Buy a complete set of 1/4, 3/8, and 1/2 inch ratchets of at least Sears Craftsman quality, and a set of combination wrenches from 1/4 to at least 1 1/2 inches. Include a 1/2 inch breaker bar. Also pliers, vice grips and miscellaneous screwdrivers. I also have a partial set of 3/4 inch drive sockets/breaker bars. Also several pullers for pulleys, etc. A tap and die set is good for cleaning up threads. I have recently bought a cheap press, saves my sledge hammers and punches. Electric drills and angle grinders and their various attachments are good for removing rust and paint. You will need a bench grinder. I have two air compressors. Your tractor will tell you what else is needed. My tractors tell me almost daily, but I can't afford daily. I wish I had the $3500 worth of tools Jim mentioned. If you call air compressors tools, I probably do. I am probably in the $1000-$1500 range for hand tools and still buying after I started this hobby when I retired about 8 years ago. I hire out any welding I need done.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.