I do not think it is a adjustment issue , more like worn or loose linkage or you have a broken roller in the range cover or on the shifting fork . adjustment is the last thing i look at . So pull the right cowl sheet metal and work your way donw and see what all is worn . everything must be snug with no play . At times the headed pins get excessive ware and they get sloppy and a little ware here and a little wear there adds up and ya get a no go . So ya start at the shifter and work your way down to the range cover and then if you have to remove it , BUT you need to pull the side cover off thew left side of the rear end so you can have access to the rev. shift fork . As the linkage to it will come out with the range cover and it will fall over and when you try to go back together you will not bet the rod back in . If you have to go that deep into it then get a book and see what your getting into BEFORE you open it up.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
