Posted by sflem849 on March 03, 2010 at 11:59:32 from (69.197.84.192):
In Reply to: H Manifold Gasket posted by 1941FarmallAboy on March 02, 2010 at 17:59:25:
MisterT said: (quoted from post at 09:38:06 03/03/10)
sflem849 said: (quoted from post at 17:23:12 03/03/10)
GordoSD said: (quoted from post at 09:18:28 03/03/10) You should have the thick manifold washers on the four studs where the manifold is split. WHile you have it iff, take it to a shop and have it planed just enough to be perfecr flat. Then sandblast, paint your choice of color with hi temp manifold paint and install.
Gordo
I was going to say leave the carb and gov hooked up if you can and try and sneak the gasket in.
I hate getting that tang lined up with the gov tube. It is also a PITA to get the nut on the backside of the carb.
I understand where you're coming from, but you'll never get the mating surfaces cleaned up good enough without total disassembly.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.