Farmall & IHC Tractors Discussion Board |
Re: Re: 12 Volt Conversion
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall & IHC Tractors Discussion Board ]
Posted by Case on May 03, 2000 at 06:55:56 from (208.191.76.67):
In Reply to: Re: 12 Volt Conversion posted by Phil Auten (TX) on May 03, 2000 at 04:45:09:
Phil The Farmall is the F-Cub model. The tractor was already converted to the 12 volt using a 12 volt coil and a ballast resister. The problem was that the system would not charge unless I over rpm'ed the engine to excite the alternator to start charging. The wiring was of suffient gauge but the switch would get very hot. The coil did ok because the ballast resistor was taking the load. I found the article written by "Genesee Products" for the proper 12 volt conversion. They recomended using the Napa IC14 coil and the Napa KSI-32 switch. I do not know if the coil has a internal resistor but I will check on that. Also the coil I got was the IC14SB. They say its the same as the IC14 but half the price. Now that you mention the coil I am wondering if it is the same. I will also check the point gap. Thank You for your input, it's given me some areas to start checking. Thanks Case
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|