Posted by eastsider on February 21, 2010 at 09:36:51 from (24.111.60.5):
Hi guys! Well, a while ago I posted the question asking for suggestions on what would make a new engine knock...the symptoms were that it ran fine, then after it warmed up there would be a light knocking toward the front of the engine.
Well, we tore into figuring it out this weekend. We started by quieting the water pump...the tensioner on the front was a bit sloppy, so we got that all fixed up. That wasn't the noise we had an issue with however. So, step 2 was to drop the pan and inspect the rods...we checked #1 rod and it was all torqued correctly and tested the fit with plastigauge and it was in tolerances. We tried #4 to see as well and it was also fine...so on to the front.
We split the front away and pulled the front cover off the engine to look at the gears. Nothing was obvious, everything looked great. I wanted to check the half moon key on the camshaft, so in beginning to loosen that nut, we noticed some "slop" between the cam gear and the crank gear... .024 to be exact...luckily, I had another cam gear that looked better, and after installing that one and a better looking Idler gear on the other side, the "slop" was now at .006...a definite improvement. So, back together it went.
That sure did it. No more knocking after warmed up now. Lesson learned. Thanks for the suggestions on what to look for! Hopefully someone else can use this information in the future! Here is a picture to see how it looked.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.