Posted by ScottyHOMEy on February 02, 2010 at 18:16:14 from (70.105.234.147):
In Reply to: Super C oill gauge posted by gary sedlacek on February 02, 2010 at 17:47:01:
The thread you see between the back of the gauge and the block is part of the gauge. If yours is a goner, you can o at it with about anything. Channel lock or a pipe wrench on the housing will usually do it. If the housing should soomehow twist toiff of the thread, a small pipe wrench directly on the threads will finish getting it out.
The replacement gauge will go on by hand. A judicious measure of pipe dope or other thread sealer (not out at the end -- you don't want that stuff getting into your oil -- on the half or two-thirds of the thread closest to the gauge will be good. Any excess can be wiped off away after you've got it on. One of those little rubber gizmos you use to grip stubborn jar lids can he helpful in winding the new one on so that it's tight and reads right side up.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.