Posted by Mark on January 26, 2010 at 16:59:17 from (75.90.232.147):
I suspect a leaking head gasket on my Super C and so, I started to yank the head. Nope..never done this before, but it doesn"t intimidate me...until I get backed into a corner..hehe!
I get everything on the outside loose, pull the valve cover and look everything over real close. There"s no getting that center head nut loose with the rocker arm in place...I cannot get a socket or a wrench on it.
Very well, I loosened all the rockers, took the rocker arm nuts off the studs and the arm assembly refuses to budge. So...just what does it take to get the rocker arm off the studs? I sure don"t want to pry or hammer on it...unless there is a specified manner to do it.
Every head nut is loose except that center one that hides below the center rocker arm support....if I can get it off....the rest should be easy. Thanks.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.