Some of the rich guys use caseih hytran. I use the 303 hytran sold by orscheln in the yellow buckets. When on sale, it is about $23 and regularly around 30. When you look at the specs, it meets ih, jd and other standards. TSC never has their hytran very cheap. Walmart carries it to in supertech with the same specs but not as cheap as Orscheln on sale and I think more than 30.
You for sure want to pull the plugs under the tranny and the rear end to get rid of any water and sludge. Its near impossible to keep fluid from being milky unless you are plowing all day with it to heat the oil enough to get rid of the water. The other problem is that the rockshaft housing under the seat probably has a couple gallons and a bunch of sludge in the bottom of it. Between that and the fluid in the system, you never get it perfectly clean. Most just live with the milky fluid unless it has so much water that it has a pukey slick greasy feel to it. Ih dealer told me it takes 2 or 3 changes to clean it up anyway.
To burp the water out, leave the fill and check plugs tight. When you remove the bottom plugs one at a time it will dump a quart or two and stop for a split second to allow air to get by, then you can stick the plug back in when you just have oil coming out.
When you pull the cover off the filter, it may dump a pint or two there.
I use Wix hyd and oil filters from Oreillys who usually stock them or can get them in one day and they are cheaper. I think IH's are made by wix anyway as they look the same.
If your fluid is just tan colored, I'm not sure I'd mess with changing it all right now. Winter is the worst time for condensation in the tranny and rear end to just add more water anyway. That and melted ice and snow and then rain that gets in around the gear shifter unless you keep it covered as well. I'd just make sure there is no water in the bottom and the filter and then wait till summer.
As you may notice from reading the threads around here, everybody has trouble with their hydraulics until the fluid warms up. Mine has taken from 15 to 30 minutes to warm up enough to quit whining. Cleaning my filter screen stops the surging if that gets bad.
I owned a 460 once and never changed it. It leaked so bad all I did was keep adding to it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
