If it has numbers on the bottom, or top/sides, the number can be referenced at a NAPA, or possibly google for it (put in voltage regulator xxx-xx-xxx) filling in the number as printed on the reg. If no numbers are on it, the pull in voltage of the cutout relay would do it.
With the following items a 6v battery, a variable voltage supply from 0-20 v, the Voltage reg in question, a volt meter (if the power supply does not have one built in), and some jumper wires.
Connect the battery + to the Power supply + Connect the power supply - (with the volts at zero) to the arm terminal of the reg. connect the Bat term of the reg to the - battery post. Connect the volt meter across the Arm to Bat terms of the VR with the black lead on the arm terminal.
Begin turning up the voltage watching the meter. as the voltage gets between 7 and 8 volts, a click should be heard as the cutout closes, and the meter across the relay should go to zero. This is a 6 volt reg. If it gets to 13 volts or more before clicking, it is 12v. If it does not close, or is permanently closed already, it is toast. JimN
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.