Posted by Janicholson on January 08, 2010 at 12:44:47 from (199.17.6.233):
In Reply to: Re: H would not start posted by John T on January 07, 2010 at 13:49:47:
The point at which peak mean effective pressure is achieved in the cylinder depends on four (primary) factors, the speed of the engine, the octane rating of the fuel, the temperature (at the top of the compression stroke in the cylinder), and the compression pressure. These affect the flame propagation rate, and thus the point at which spark based ignition should occur. The near zero RPM of hand cranking, and the resulting modest compression, and ambient temp. usually need a TDC setting for zero chance of kickback. This should be the setting for all ignition systems used on hand cranked engines. It does not drive the total advance, nor does it affect the advance curve. If modern fuel is considered, and RPM is still at 1600 to 2100, total advance must still be in the mid to high 20s. This is due to the relationship between flame propagation rates and RPM. In slow turning, low compression engines, compared to the Automotive engines of today, the advance seems insufficient, but if taken higher it will detonate. Advance should be set to produce the first hint of detonation (knock). At that setting, the Peak pressure is going to arrive near 4 to 6 degrees ATC. This is the sweet spot to gredge power out of the combustion, without driving the rings down around the skirt, or making holes in pistons. I love it!! Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
