Posted by John Gustafson on January 02, 2010 at 19:42:22 from (72.173.192.59):
In Reply to: Is my float sticking? posted by Faster346 on January 01, 2010 at 10:03:44:
Many years ago back in the days when I had a boat I ran into a similar problem. The manufacturer in his wisdom had placed the tank vent on the side of the boat facing forward. Salt water, spray gets in the vent, non stainless tank, it started shedding rust. Ultimate fix was rotating the vent to face backwards.
Engine was a 4 cyl Chevy with a Rochester 2 barrel in it and started having flooding and hard starting problems. Then suddenly it would only run at idle or a little off.
Answer was little globs of rust had migrated through the fuel pump and were holding the float valve partially open and choking off full fuel flow. A lot of effort to fix this. Including pulling, cleaning and and re-coating inside of tank, figuring out where water was getting in in the first place (one was NOT happy when I found that), but I also added an inline filter just ahead of the carb. That got changed out at the annual spring tuneup and cut open just to see. First year I still got some chunks out of the filter. After that it was smaller stuff but there always was some debris in there. Problem cleared up permanently after that.
Just a piece of personal experience along the lines of your problem.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
