I have a 240U with a Wagner-IH loader. It's a pipe loader, but is a pretty substantial pipe loader witha 2 cylinder hydraulic bucket. From the existing plumbing on the tractor, it appears that it was hooked to the tractor pump at one time in it's life, but when the PS was added, it took enough flow away that a separate crankshaft driven pump was added. The loader works plenty fast now, but the 3 point (just like your 3 point) is starved when the engine is idled down.
As for an upgrade from your 8N, you have the advantage of live hydraulics, more weight and a few more HP, but the drawbar pull will be better, due mainly to the lower gearing, not HP. The engine is rated at 40, but the Pto is closer to 30 and the DB more like 26-28. I may be off, but I believe the pto on the early 8Ns was 22 and later 26HP. You will no doubt find you need more weight on the rear like I need... still looking for weights for 24" wheels. Have found some for 28", but the 24s seem harder to locate.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.