Posted by Owen Aaland on December 27, 2009 at 02:03:03 from (65.165.246.148):
In Reply to: 186 electrical problem posted by Bernie Steffen on December 26, 2009 at 17:26:34:
Mike 186 said: (quoted from post at 21:26:34 12/26/09) I got a 186 hydro. The problem is the alternator doesn't charge at low idle. The volt meter gauge stays in the green if you rev it up a little but still acts erratic or it doesn't charge like it should. alternator is only 2yrs old. I was wondering if I need to change the belt. I don't have a warm shop so any pointers would be greatly appreciated.
Certainly check the belt but if I had to make a guess as to what the problem is I would say that vibration has shorted out the stator in the alternator causing it lose a lot of its' output amps.
A lot of rebuilt alternators have the stators reused when they are rebuilt. On tractors and other farm equipment the heat and vibration is usually what kills the alternator. Most stators use paper spacers to keep the stator windings from rubbing on the stator laminations. The heat dries out the paper causing it to become brittle and loose and then vibration wears the insulation off the windings. If part of the stator windings have turned black it is an indication of them being shorted out. They change color when they are overheated.
The other problem that is real common is the brushes wearing out in the holders and sticking. Your tractor should have a 10SI, type 116 which has swing style brushes instead of sliding ones. That change eliminated a lot of brush problems on the tractors.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
