Posted by Nebraska Kirk on December 26, 2009 at 19:53:49 from (207.91.4.156):
In Reply to: 1948 MD posted by Adam Wiles on December 22, 2009 at 06:03:19:
Bates Corp. has new 4" pistons, $203 each though :shock: IF it was me and IF the owner kept the old sleeves and pistons, and IF just one sleeve needs to be replaced, and IF the other three sleeves and 4 pistons are in good enough shape, I would reuse them and then just find a good used 3 7/8" sleeve. A lot of ifs, I know :lol: But since new parts are so expensive and the tractor will probably not be used 8-12 hours every day earning a living, then I would be more inclined to go this route. Hope it does not need main or rod bearings, main bearing set will run you $500 or more; rods, $160 for set of 4.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
