Posted by CNKS on December 25, 2009 at 12:34:04 from (216.144.104.128):
In Reply to: C113 rebuild questions posted by WellWorn on December 25, 2009 at 09:06:42:
It depends on whether or not you want to be sure it is fixed, or be looking for leaks every time you use it. El Toro gave you the "best" block number as that block is used for the C123 in the Super C and Super A1. It was sold with thick sleeves to give 113 cu in in later Super A's and C's also. Advantage is the overbore kits use thin sleeves to give a bore of 3.25", 132.7 cu in. No reboring necessary. You can also use older blocks, that were originally C113 as in your tractor, engine kits will result in 3.125 inch bores 122.7 cu in. Plan on an excess of $500 for the kit, plus maybe another $3-400 for hot tanking, head work and crankshft grinding. I am currently having my Super A engine done that way and hope to come in under $1000. You can also do what Gene says for a lot less money. I'm not arguing with his success.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.