Posted by ScottyHOMEy on December 19, 2009 at 19:13:13 from (71.241.215.22):
In Reply to: Re: H starter ring gear posted by redihplower640 on December 19, 2009 at 18:44:06:
No. The 180* advice is off. The quarter-turn, 90* is more to the point. A motor will come to rest when fuel/power is cut off and it will kind of settle when the last compression stroke not being driven by a combustion stroke on another piston wil provide enough resistance to stop everything. That is what tends to leave the ring gear resting in one of four general (not exact) positions that will take the most wear when the starter is next engaged. Soa a 180* turns won't gain you as much as a 90* turn.
But if you're going to heat it up to turn it 90*, you might as well take it off and turn it over. Depending on how bad it was chewed up on the original surface, it may take some dressing with a file or grinder so that the new side presesnts itself as square, but that's about it.
The faces on the ring gear are square. The bevel on the starter pinion are designed to synch and make the mesh.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
