Posted by deano4863 on December 18, 2009 at 20:09:07 from (76.30.75.21):
Hi Guys, I have a 52 Farmall H that I bought out of an old shed. It had sat for at least 10 years. Motor was siezed. I got it loose and the initial compression tests on 2,3,& 4 were 140-145. #1 was 110lbs. After all the various concoctions and soaking the compression is now 140-145lbs on all cyclinders. Oil presure stays between 55-65lbs. It starts and runs really good has lots of power and will run a 7" shredder in knee high grass with little effort. I have skidded 5-6 logs and it lugged down,lost traction, and just spun the tires. It never did kill the motor. The motor smokes and uses a quart of oil in 3-4 hours. About all I have ever done was some shredding and riding around. Until tonight!! I hooked on to my hay rack and hauled 20 people around to look at Christmas lights in our subdivision. We had a great time till we got back to the parking lot at the grocery store and realized everybody was covered in oil spots. Apparently this motor is spraying oil out the exhaust. I ran my finger around the muffler exit and it has about an 1/8" layer of grease in it. Looks like I need to get into the motor. The way it runs I sure wouldn"t think it needs a major overhaul. Please express some opinions on whether I can just put some new rings in? It has stepped head pistons in it, do you suppose that the engine was rebuilt and the valve guides have never been replaced? Can you have that kind of compression and still have bad rings? Thanks in advance.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.