I am not an identity expert on plows, but it does not look like an IH plow. It is missing coulters A flat disk like cutting wheel preceding each moldboard cutting vertically to make a clean strip of soil to turn. They are mounted on an adjustable frame attached to the beam above the moldboard. The Shin (missing piece) is easy to re attach and will Be OK. I would replace the shares (Bottom edge of moldboard as well, those look like they are not serviceable (But I am not sure what the new ones would look like) The land slides might be OK (flat vertical plates behind the shins) They might need to be adjusted to limit side force caused by the wedging action of the moldboards. this pulls the tractor to the right in the field, and makes steering straight a tough thing to do. Use a rubber disk abrasive wheel on the surfaces to pre-shine them, with the polish marks in the direction of the soil travel. Scowering (letting the soil polish them) those parts (unless you are in sand) will take a while if not pre-shined. The tractor will pull it well. If this is the first plowing you will do, invite a old neighbor over to play. It will be invaluable. JimN
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.