OK, what is this a "single point", a "fast hitch", or just what?
IN this pic you can see that the long link from "the box" to the fender mount shaft is missing. If someone can give me an eye--to--eye length and show me what it looks like, I could make that. Also, what does the spring and the second pivot buried to the rear do?
Below, we see the rear shaft, so what does this make this unit? I have no idea what the extra piece welded to the shaft is. You can see there's a horrid drawbar someone "built"
Below we see the quadrant. What do these do? One is lift, the other equalize? The control rod for the right hand side lever is gone, so I"ll have to make one of those
Below, right side of "the box." If there's any linkage that belongs on there, , it's gone. Anything needed there?
The pump. Not much to say there, I guess
Below is the right front steering arm. Can you rotate these or heat / bend them to get them away from the tires?
This post was edited by 440roadrunner at 14:46:41 11/30/09.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
