Posted by John A. on November 30, 2009 at 10:16:36 from (76.1.122.170):
In Reply to: 4020 vs 1066 update posted by Wendell Burton on November 30, 2009 at 05:29:51:
Wendell, In this Economic climate I think it is a good decision. Not having a major capital outlay now is smart! Unless it is absolutely necessary for you to carry on your Farming activities. For the last 4 yrs are so I have had the pleasure of running a JD4230 which is a 4020 in 30 Series Tin. I have a 73 966, Both have their Strong points and Short comings. You have not said if your 4020 is a Straight 8 Speed standard or a Power shift! The 4230 I have ran is an ol Straight 8 Speed This tractor is really sweet on a 15 ft Batwing Shredder, Where I still prefer My 966 on All tillage activities Just my thoughts here. Take care! Later, John A.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.