Posted by CNKS on March 07, 2009 at 18:01:30 from (216.144.104.128):
In Reply to: Re: 460 power steering posted by mattofvinings on March 07, 2009 at 15:53:59:
Thanks -- My concern about the worm gear oil is that it is contaminating the Hytran as there is no seal between the gear box and the power steering unit, at least not that I have found. I wonder if I shouldn't just use Hytran in the whole thing? The manual is rather vague on that. I am also hesitant to replace a vented plug, but since it is already leaking, there is nothing in the unit to damage except maybe to cause a bigger leak, which ultimately may come out the top of the steering column, but I don't think so. The unit has no springs, it does have a spool, the oil is directed left or right to the piston (which is connected to the rack) by the plungers and spool in the valve block. That is my oversimplified explanation, anyway. One thing I did not mention. This problem did not start until I hung a bush hog on the fast hitch after adjusting the Tel-a-depth so that it worked properly. It did not leak by just raising and lowering the empty fast hitch. That was before I realized that the previous owner had plugged the hole in the cap on the main reservoir -- but, the lift works fine. The PS pump on the 460 is mounted on the main hydraulic pump. The power steering works fine too, except for more pressure turned fully to the right. Not sure how all this ties together as to what pressure goes where.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.