You make a good point about rough pieces. I haven't seen any pics of Mike's manifold since it came out of the tank. It looked not-too-bad before it went in, so he may have a pretty good surface going.
Where he's starting from being pretty clean, the Must For Rust (Never heard of it, but there are a lot of things I haven't heard of!) sounds perfectly adequate. Any mild phosphoric acid solution will do what I'm talking about.
What I would urge him to stay away from is a product like the aerosol PermaTex Extend Rust Treatment. It's basically a clearcoat with an acid of some sort in it to convert the rust, but leaves a clearcoat in place that, depending on what one put over it for paint on a part that doesn't get hot, might make for the lifting and peeling you describe, but will definitely do it on a manifold.
Whatever name-brand product he winds up with, I think the plain acid solution of whatever strength will do what he wants (stop the rust and stabilize the surface) and leaves his options open for when he goes to finish it, whether that be plain old stoveblack or a paint that's made for the heat it will see.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
