Posted by Dave J. on November 27, 2009 at 10:15:02 from (75.60.209.102):
In Reply to: sticking brake on an M posted by Rusty Acres, ND on November 26, 2009 at 20:58:20:
I had the same problem with my Super C. The ball bearings in the actuators were a little rusty, and would stick. I took them apart and cleaned them well. I put just a slight coat of Never-Seize in the slots,and on the ball bearings. I have read other places not to do that.., AFTER I had done this. I've never had any problems with doing this. Just don't over do it.
I have also had them grab in the spring, when they sweat, and cause possibly a little rust on the face of the acutuators. It only does it going forward. I simply put it in reverse, at at an idle, and ride the brakes a bit. Seems to clean them up, and work smooth afterwards.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
