I started droving my father's F-12 when I was about 8--stretching to reach the clutch, with my fanny almost on the left brake drum cover. Nothing was going to stop me, and nobody tried to(tell that to OHSA today). We had 30 cows and a Dual Manual Manure Extractor (two scoop shovels). Usually, the hired man did most of the mucking out, which in the winter took from 9 a.m. to probably 4 p.m. I didn't care much for the shoveling, but I was desperate to drive the tractor to the field, so I always managed to be around to help out the hired man with at least part of the load. He probably didn't want to go out in a windy field in January, so there were no protests when I started for the field. On one of these joyous excursions, there was snow on the ground. I ALWAYS drove flat out (four mph) and usually pulled the governor rod to get just a few more rpms. Sometimes, there would be a tiled drain in the field that would break and start a washout. This usually left a good sized hole in the ground. Well, you guessed it. I'm barreling through the snow and couldn't see the camouflaged hole. Wham! The front end went down, the bolster snapped off and the tractor lunged ahead a few feet until it stalled after digging a trench in the ground. Long walk to the barn, long face. I looked at my father and said, "I broke the front wheels off." He never said a word, and to this day, I do not know what he thought. The next day when I got home from school, there was a new bolster on the tractor.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
