Posted by pete 23 on November 23, 2009 at 11:04:12 from (173.87.147.73):
In Reply to: Re: help 1206 posted by Michael Locher on November 23, 2009 at 09:22:01:
First off, diesel repairs shops always put their own seal on pump so any adjustments would no doubt need their permission. Original 1206 was rated at 112, although I don't recall ever seeing one that didn't put out more than that. The main adjustment gets kind of tricky as you need to remove a few components to get at it and it is just quess and by golly until you dyno it again. I would certainly inquire at the shop who rebuilt pump before making any adjutments. On to something else here, you say you have some parted 361 engines, do you by chance have one you can measure the piston protrusion over block at tdc on one that did start easilly. There are no specs in IH service manual and at my age, memory doesn't always serve me correctly. I found specs from machine shop that says .030 to .037 protrusion but that seems a little high to me. Sleeve flange height is .030 to .040 and I am good with that.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.