Posted by Buckskintractor on November 19, 2009 at 17:10:52 from (173.22.60.174):
I have a Farmall Super M. I replaced the brake disks, balls, and springs on one side. I also had the inner parts sandblasted and had a small amount of the surface where the pads meet machined to insure smoothness. This should be like new. That wheel continued to lockup. It locks so tight that I have to back the tractor up to unlock it and it does so with a bang. The brake (side) that I did not replace parts works without locking up, but has poor braking. I have taken this (repaired side) apart 4 or 5 times. Everything is as it should be. I have asked several local mechanics and no one can tell me the cause. That wheel locks so badly that I almost rolled the tractor while going down a hill, fortunately a tree stopped me from sliding sideways. I can not use the tractor this way, since I live in a hilly area. I do not know what to do anymore. A guy at a local machine shop who sandblasted the parts and turned down the surfaces said he has a "M" with the same brakes and he has the same problem. He said there is no fix for this except to take the "damn thing" apart every time he uses the tractor. The last time I had it apart I put some oil on the splined shaft and the brakes worked perfectly for a week, then all the locking up started again. What the heck is the problem? I am about ready to sell this tractor and get another "H" like my old one which had trouble free reliable band brakes. These disk brakes are horrid, but I hope someone on here knows what to do, since no one locally seems to know.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
