Posted by pete 23 on November 09, 2009 at 16:29:54 from (173.87.147.73):
In Reply to: 1086 injectors posted by jim dehoff on November 09, 2009 at 04:27:28:
First off, drain the coolant as the injection nozzles fit in a brass sleeve which is directly exposed to the coolant so if sleeve loosens you may end up with cyl full of coolant. Second, don't twist back and forth as this will only make them bind tighter. They should actually just pull out easily if top dirt seal and lower compression seal are good. Usually just a small rolling head bar will pop a tight one out but you may have to devise a puller. Before installing them clean sleeve good including the hole in bottom where tip extend into comb chamber and try fitting injector into sleeve with out the top seal to make sure it drops right into bottom on it's own weight. I have seen them where they leak combustion after installation due to the carbon build up in that hole and injector not bottoming out really easy. Torque clamping cap screw to only 12 ft lbs .
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.