I hesitate to mention this because I don't know exactly what the problem is.
I am assuming that the hole is a through hole into the water jacket because you are working on the block. Yes, a torch will work but you haven't got one. Cast iron will not oxidize as fast as steel when one hits the oxygen lever. I torch out steel pipe from iron fittings all the time.
You said there is only a small piece of the tap and it is near the end of the hole. Let's assume that the last 1/3 of the hole is expendable. Let's also assume that the cast iron surrounding that 5/16th hole is about 1" thick. That's reasonable because the pattern maker would have beefed up areas around tapped holes.
You could take a piece of 1/4" pipe (that's a nominal size, actual size is over 5/16th" on the ID), cut it to fit between the inside of the water jacket and something solid. If there is nothing solid, put a piece of heavy flat bar in there as a bridge. The pipe gets centered on the hole and is tight. Now drive the tap through the cast iron into the pipe.
Install the new stud with Threadlocker or epoxy. I think 1/2" of thread in the cast iron would be enough but you will probably have more. I don't think you will have a big divit on the back side. Just four small thread tear outs. If you are lucky the only damage will be to the tap as it shatters into small pieces.
If you are not lucky, and you cave in the whole side of the water jacket, will you forgive me?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
