|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Rear end fluid
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall & IHC Tractors Discussion Board ]
Posted by The Red. Hmmmm on April 23, 2000 at 13:56:31 from (12.75.221.16):
In Reply to: Re: Re: Rear end fluid posted by TxFarmall H on April 23, 2000 at 13:48:10:
Jason, personally I would change it but lets see what other folks have to say. I am trying to recall. I think I got around 5 gallons when I drained the rear drain and almost a gallon from the front drain. You get about a quart from the pulley facing when you jar it loose. It is purposely designed to hold 90W to lubricate the two ball bearing assemblies in the belt pulley assembly. If you decide to replace it, I recommend you pull the 4 bolts out of the face casting on the flat belt pulley assembly and tap it loose and drain it also. I got about 1/2 quart of water and 1/2 quart of 90W. When you tighten the face back up, there is a filler plug on the top of the pulley assembly. Add one quart of 90W, of your 6 gallons, in there. 90W is cheap and you won't have to mess with it for 5 to 10 years depending on your maintenance schedule.
Follow Ups:
Home
| Forums
Today's Featured Article -
New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
