Posted by CNKS on October 25, 2009 at 17:16:42 from (216.144.104.128):
In Reply to: Painting MD posted by BruceS. on October 25, 2009 at 11:15:20:
This is a common question on the Paint and Bodywork Forum on this site. First you don't need the etch primer, it is made for new metal that bodyshops don't want to sand. If sheet metal, sand it with 180 grit, clean it with wax and grease remover and apply epoxy primer -- not from spray cans, but real two-part epoxy. If cast wire wheel and clean it good. Different brands have an application window usually about 3 days - one week. So before you topcoat or apply surfacer, scuff it with a scotchbrite pad and apply another coat. The bond between the epoxy and the next layer must be chemical and not mechanical, thus the window. Epoxy is water proof. Read other info on the Paint and Bodywork Forum.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.