farmallhal said: (quoted from post at 10:15:04 10/22/09) Rusty, I'm not involved in this string but I have a correct and original 1951 M with a T casting code on the tractor. It is located on the engine block and as I recall was cast in late October 1950. I also have other components with U and W codes. The U was used a short time in early 1951 before going to the W code for 1951 parts. As I recall on my tractor all the U parts had January dates so anything cast in a later month had the W code. The latest casting codes are on the rear cast wheels and were cast in mid-March 1951. My tractor has a 2538XX S/N and from prior research was out of the factory in early April 1951. You should be able to use some of this information to provide Mike a fairly close S/N on his tractor as 41,000 were produced in 1951 when more were made then any other year. Hope this helps, Hal.
Yes, that's why I say the casting codes are good only for a generalization. One book I have insists that the letter "U" was never used, but you just proved that is wrong, and I have observed a few other Farmalls with that "U" casting code.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
