Posted by dpski on October 20, 2009 at 06:33:51 from (128.221.197.56):
Hello, just joined the ranks of the red team and picked up a 53 Super C with a Fast Hitch. I"ve been reading through the owner"s manual that came with the tractor, but there must be a separate manual for the Fast Hitch which I don"t have.
If you're standing behind the tractor looking at the fast hitch, there is the U shaped rockshaft that pivots up and down. It mounts in two plates attached to the very bottom of the differential. The Right side plate has a round hole, the left side plate has an oblong hole, which I assume is there to provide some sort travel to adjust the left-to-right tilt of the entire rockshaft. There is some freeplay in this entire assembly. Judging by the parts diagrams on Case-IH parts online there is some sort of bearings/bushings in the caps that go around the rockshaft and attach to the plates. My question is just how much freeplay should there be? The bearings don"t appear to be typical roller or ball bearings, but more like bushings of sorts. I assume designed to wear out first. But how much wear is too much?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.