Posted by big_red_man on October 18, 2009 at 17:08:02 from (24.206.119.177):
In Reply to: IH milkers posted by IHDairy on October 18, 2009 at 12:04:22:
We used IH milkers on our Grade A dairy farm in central Nebraska from 1948 until we replaced them with a Surge pipeline milker (early 60's???) One bucket held five (or was it six???) gallons, but was only for one cow (not equipped to milk two in the same bucket). Those buckets were darn heavy when full and with the stainless steel bucket, pulsator and all hoses probably weighed about 70 pounds. Also our Holsteins gave too much milk for more than one cow per bucket.
I remember we carried each bucket from the milking area into a separate room, to the bulk milk cooler, removed the top, then stepped on a couple of concrete blocks and poured the milk into the strainer. What a lift that was!
I remember that in the winters on cold days it was very hard to make the pulsators work. We had to remove a cap on top of the pulsator and use a finger to manually move the "innards" back and forth until it warmed up. And sometimes the electric motor couldn"t start the vacuum pump it was so cold!(oil so stiff). In the early years the folks had a model a ford. It had a regular water faucet installed on the intake manifold. The idea was that if the electricity failed, they could use a garden hose to provide vacuum for the milking machines. I don"t recall they ever used that system. Electrical failures were very rare on our farm in the 50"s to 80"s.
Glad to think of milking twice a day every day of the year. It reminds me of why I haven"t missed it since leaving the farm.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
