Posted by FarmallMatt on October 14, 2009 at 17:50:41 from (71.234.106.161):
I just bought an old A with an H4 magneto but someone had already taken the condensor out and the tip of the condesor was broken off. By looking at pictures of complete magnetos it seems that I am missing a screw and nut on the outside of the magneto. I think I am missing a piece that is supposed to go outside the magneto to connect to a kill switch wire. However I purchased a Magneto kit with new condensor and the new condensor has a threaded brass tip which does not seem to reach outside of the magneto housing. Upon further examination I notice that YT sells two types of condensors in their kits and one seems to have a small nut at the end of it. I purchased mine from tractor supply but can anyone tell me if there are two different condensors used in the H4 type magneto. and if so am I going to have to get more parts to fix this problem? Thanks and I hope my description was clear enough to follow to hopefully get some help. Matt
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.