Posted by Eric Kaltenbach on October 09, 2009 at 09:15:28 from (65.215.14.1):
I have a International 544 that I had to have the motor bored and sleeved. When put back together couldn"t get it to pick up RPMs but it would run. The timing and valves all seem fine enough to where the tractor should run. I just cleaned and rebuilt the carburetor because it acted like it was flooding it self out. Then I found out that it really wasn"t firing right. It would only fire when I held the starter button in and never fire enough to run more than a half a second. Seemed like good spark in 1 and 2 plugs no spark in 3 (which was the cylinder that needed bored out cause it was cracked)and #4 plug was fouling out. So I replaced all wires, plugs, distributer cap, roter and the coil. Now it won"t even fire, just rolls over. I don"t know what seems to be wrong. Everything is mechanical sound. Now what, new points and condenser, reconsider a timing problem? What could be some other things I could check or consider to be causing problems?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
