Posted by Owen Aaland on October 07, 2009 at 18:15:42 from (207.13.114.55):
In Reply to: 300u clutch posted by JSmith Farm on October 06, 2009 at 13:35:44:
I don't have a problem with adjusting the levers when the friction surface is remachined but it need to be done before the clutch is reinstalled. Even then, if much adjustment is needed, most likely the cast plate is junk and the readjustment will not compensate for the loss of material. A worn out cast plate will leave you with springs that no longer have the correct compressed height and result in less clamping force. The geometry of the levers will also be off because the pivot holes are too close to the friction surface.
The levers need to be set within a few thousands of an inch to being the same height or it will cause the bearing to wobble when the clutch pedal is applied. Many rebuilders actually make the final adjustment by grinding the contact point on the levers to ensure they are in perfect adjustment. Even a slight misadjustment will cause accelerated wear on the clutch release bearing and carrier parts. You may be able to get by with it on a hobby tractor that isn't used much but on one that is being used regularly you are just creating future problems. If you think that the levers need adjusting after replacing a disk you have more problems than a lever adjustment is going to cure.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.