Posted by MHMalcolm on October 06, 2009 at 15:06:50 from (66.66.148.252):
In Reply to: 300u clutch posted by JSmith Farm on October 06, 2009 at 13:35:44:
You say the fingers pressed all the way in when you bolted the pressure plate to the flywheel. If I'm interpreting what you are saying correctly, it sounds as if your new clutch disc is too thick for your pressure plate. The distance from the friction face of the pressure plate to the release bearing contact surfaces on the release fingers needs to be adjusted to 2-7/32" after the pressure plate is bolted to the flywheel. If it is any less than that, the clutch won't release all the way or at all. If this dimension was correct, then you will need to adjust you clutch pedal free travel with external clutch pedal linkage. If your tractor has a torque amplifier, this adjustment is a little more involved. My email is open. Send me an email and I will email you a scan of the adjustment procedure.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.