Posted by IH fan on October 04, 2009 at 17:38:42 from (70.243.240.19):
In Reply to: 1486 needs more power posted by Larry B 1486 on October 02, 2009 at 19:42:10:
[quote="Hugh MacKay"](quoted from post at 04:40:55 10/04/09) IHFan: If it takes 1 minute per bale to wrap and dump, that is 40 minutes of the hour used up. You do the math, leaves 20 minutes for actual baling. I've never been able to take 40 minutes out of an hour and still have an hour left. Gosh, the work I could have done with your math.
quote]
Okay, I was looking at rolling the hay into a bale and wrapping the twine or net as "wrapping the bale", not just finishing it, but including wrapping the hay into a bale. If he was doing 30 an hour, that's 2 minutes per bale... I haven't been around a round baler much, but that sounded reasonable to me, maybe not.
I pulled a square baler over many miles of hay fields, starting at age 10 with a JD A and a NH 77. I remember driving the A at least one year before Dad bought his first 60, so I was 10 at the time (1952). Needless to say, Dad was loading bales behind the baler when I was driving, and back then not everyone owned his own baler, so Dad did custom baling. $ .10 a bale dumped on the ground, $ .11 if he drove and the customer loaded, and $ .12 if I came along to drive and he loaded.
As for my math, if he has baled 137 in 4 hours, that's 35.5/hr.
This post was edited by IH fan at 17:44:38 10/04/09 2 times.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
