Bernie: You go to a shop the specializes in bearing and seals. Take along your proposed hubs, and the spindle your going to use. I was amazed the first time I tried this on trailer hubs. He told me, didn't matter tractors, trailers, etc., as long as hub size is large enough to give bearing space between axle and hub.
Over the years (1940s to 1970s) two different size spindles were used on large Farmall front ends. As loaders came along, so did large spindles. I've never seen newer that 460-560, or later models with small spindles. Those hubs should be large enough. Now, if you told me the hub came from a 140 or 240, probably it wouldn't slide over M axle without bearings.
There is always an outside chance the bearing shop can't make the fit. I'm saying it's worth checking it out, both supply and cost. New bearings and seals will give you many years service. I do know this can be done between Super A, 100 and 130 with cast wheels and 140 with disc wheels.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.