Posted by ScottyHOMEy on October 02, 2009 at 08:27:02 from (70.105.224.197):
In Reply to: Heaters posted by Dave H (MI) on October 02, 2009 at 07:42:46:
I've got a little 30,000BTU propane salamander type heater that works pretty well. It'll run 15 hours or better on a 20-lb tank of propane (at local prices that's about $0.85 per hour plus whatever electricity the fan uses).
Like the use it sounds like you would put one to, I generally run two or three hours at most. It's nowhere near big enough to heat my entire two-car garage, but it's plenty to warm up the quarter or so of the area that I might typically be working in. That also helps disperse the fumes over the whole area. Where CO is about the same weight as free air, I'll usually raise one of the roll-ups a few inches and crack a window at the end opposite just to keep a little fresh air cross ventilation going. I've worked around it for as long as five or six hours that way with no ill effects.
I've found it more effective for heating a little larger area than a convection/ceramic type heater, making things more comfortable whether I'm just puttering, or actually working on something. The only gripe I have with intermittent heating is the condensation that will form on the tools if it's quite cold out. My way around that is to organize whatever I'm doing so that I'm not warming up the area with the tool chests so much. It means a little extra walking (What? 10 feet?) for the tool I forgot to get out but not a problem. The tools I use on a job are going to get cleaned up and wiped down anyway.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
